Downloads
FAQ
-
If I am using low-impedance (Lo-Z) connections, can I connect the speakers to the MA/PA Series with an impedance of 2Ω?
-
Can I use a condensor microphone with the MA/PA Series?
-
How many VXC/VXS series speakers can I connect to the M/PA Series using high-impedance (Hi-Z) connections?
-
How to place the device(s) on a table?
-
How to install MA/PA Series on an EIA standard rack?
-
If the MA Series and PA Series are connected, which settings can I control individually?
-
The DIP switch setting for SETUP seems to be ineffective.
-
Do the MA/PA Series feature any protective functions?
-
Would changing the ST Source on the MA2030a cause switching noise?
-
Can I disable the Stanbymode on the MA2120 and PA2120?
-
If ducker is turned on for MIC IN1 and 2 of the MA2030a and both microphones are used at the same time, which input will have priority?
-
What is the Leveler function on the MA Series?
-
To which input is the Leveler function on the MA2030a applied?
-
Can I disable the Feedback Suppressor function on the MA Series?
-
Can I disable the HPF (High Pass Filter) for MIC IN on the MA Series?
-
Can I apply Speaker EQ for VXS or VXC series to third-party (non-Yamaha) speakers?
-
How can I contorl DSP functions of the MA2120?
-
To which input is the Leveler function on the MA2120 applied?
-
Up to how many DCP1V4S units can be connected to a single amplifire?
-
Can I connect any controllers to the unit?
-
What kind of cables can I use to connect the DCP Series to MA/PA Series?
-
What is the maximum length for the cable that connects the DCP Series and MA/PA Series?
-
How is the volume control of the MA/PA Series related to the volume control of the DCP Series?
